Denon Pro DN-990R MD Recorder + DN-951FA CD,CD-R Cart Player

DN-990R + DN-951FA + 5x ACD-5B Cartridges in goede staat,
incl. AC aansluitkabels en manual's:

Optie:
Extra ACD-5B Cartridges in goede staat,mininimale afname 10 st.: 65,- Euro,meer aanwezig.

DN-990R:
- Instant-Start (Playback starts less than 0.01
sec. after the PLAY button is pressed.)

- Defeat SCMS (Serial Copy Management
System):
Recording is possible without reception of the
copy defeat restriction. Writing of the copy defeat
code is On/ Off selectable.

- Chassis width of only 144 mm allows the
mounting of 3 players in a 19” rack unit. This reduced width
also means a smaller footprint when used on the table top.

- 13-character information display
- 24-segment peak-level meter with overload indication
- 3-digit track number display
- Track Search Select knob (Easy track selection)
- Play mode:
- Continuous: Play a whole disc
- Single: Play a track
- Repeat: Repeat the playback

- Finish mode:
(only when l Track play is selected )
- Stop: Stop after finishing to play a track
- Next: Standby at the beginning of next track
after finishing to play a track
- Recue: After finishing to play a track, standby
at the beginning of the track
- Auto Cue:
The pickup is cued to the position within
the track where the sound starts and enters
standby mode. The sound detection level
can be set within a range of -36 to -72 dB.
- Back Cue:
When the standby (STDBY/CUE) button is
pressed during playback, the standby mode
is set with the pickup at the position where
playback was last started.
- End Monitor:
Pressing the END MON button during standby
instantly previews the end of the track, thus assuring
perfect “outros”. The point at which monitoring starts
can be set within a range of 5 to 35 seconds (7 steps) prior to the track’s end.
- End Of Message (EOM):
At the end of a track ,the PLAY/ PAUSE button flashes,
providing a visual warning to the operator that
the track will end shortly. The point at which the flashing
begins can be set within a range of 5 to 35 sec.
(7 steps) prior to the end of the track.
- Selectable Pitch (Standard or +2%)

Specifications:
Type MD Cart Recorder
Audio Channels 2 channels
Playback: Stereo / Mono selectable
Recording: Stereo
Playback System Optical pick-up system
Recording System Magneto-optical overwriting system
Signal Compression System ATRAC
(Adaptive TRanstorm Acoustic Coding)
Rotating Speed Approx. 400 - 900 rpm
Recording / Playback Time 74 min. (Stereo),
148 min. (Mono playback)
Quantization Bits A/D converter: 16-bit Sampling Frequency 44.1 kHz
Total Harmonic Distortion 0.012 % or less

(Playback, A filter)
0.02 % or less (Recording, A filter)
S /N ration 92 dB or higher (Playback, A filter)
84 dB or higher (Recording , A filter)
Channel Separation 86 dB or higher (Playback,A filter)
80 dB or higher (Recording, A filter)
Frequency Response 20 ~ 20,000 Hz (+0.5, –1 dB)

Analog outputs:
Transfer and connector Balanced (active), XLR connector
Output level +18 dBm, 600 ohm
Output level adj. range +22 dBm to –20 dBm
Headphone 20 mW (30 to 40 ohm)

Digital Output:
Transfer and connector XLR connector
Signal format AES/EBU
Output level 3 Vp-p, 110 ohm

Analog Inputs:
Transfer and connector Balanced (active), XLR connector
Input level Balanced: + 18 dBm, 10 kohm
Input level adj. range +22 dBm to –6 dBm (Balanced)

Digital Input:
Transfer and connector XLR connector
Signal format: AES / EBU
Input level 3 to 10 Vp-p, 110 ohms

Serial remote RS-232C, D-Sub 9-pin
Parallel Remote D-Sub 25-pin
Power Supply AC 220V
Power Consumption 32W
Dimensions 144 (W) x 133 (H) x 401 (D) mm
(without feet)
144 (W) x 146 (H) x 401 (D) mm
(with feet)
Weight: 5.8 kg

------------------------------------------

DN-951FA:
• Index Search
The Select knob can be used to perform an Index Search when the INDEX button is ON.
(This button switches functions between the track selection mode and index selection mode.)

• CD-R Reading Capability
DN-951FA reads CD-R discs with or without T.O.C.
(Certain restrictions may apply for playback of CD-R without T.O.C.)

• Narrow Chassis
A chassis width of only 144 mm allows the mounting of 3 players in a 19” rack unit. This reduced width
also means a smaller footprint when used on the table top.

• FL Display, Illuminated Buttons
• Track Search Select knob (Easy track selection)

Play mode & Finish mode;
1) Play mode:
- Continuous: Play a whole disc
- Single: Play a track
2) Finish mode (Stop, Next, Recue)
You can set following modes with combination of RE CUE and NEXT TRACK STANDBY in Preset
mode when Single Track play is selected
- Stop: Stop after finishing to play a track
- Next: Standby at the beginning of next track
after finishing to play a track
- Recue: After finishing to play a track, standby at the beginning of the track

• Auto Cue
After a track is selected, it is automatically cued to the point where audio starts.
Cueing takes place at the point where audio starts rather than where the track starts. The level at which sound is first detected can be set between –36 to –72 dB
(7 steps).

• End Monitor
Pressing the END MON button during standby instantly previews the end of the track, thus assuring
perfect outros.
The point at which monitoring starts can be set within a range of 5 to 35 seconds (7 steps) prior to the track’s end.

• Pitch Control (in the Preset mode)
• Instant-Start
(Playback starts less than 0.01 seconds after the PLAY button is pressed)
• Auto Track Select System (ATSS)
The cartridge operation of the DN-951FA permits the use of the bar-code based Auto Track Select function which offers simple and sophisticated control over track
replay selection.
Rich Array of External Control Terminals

Specifications:
Type CD Cart Player
Audio Channel 2 channels (Stereo/Mono selectable)
Digital Filter 18 bit 8-times oversampling

Digital filter
Quantization Bits 16 bit
Sampling Frequency 44.1 kHz
Total Harmonic Distortion <0.008 % (1 kHz, 0 dB

Playback, A filter)
S/N ratio 95 dB (1 kHz, 0 dB Playback, A filter)
Channel Separation 90 dB (1 kHz, 0 dB Playback, A filter)
Frequency Response 20 ~ 20,000 Hz
Analog output (1 kHz, 0 dB playback)
Transfer and connector Balanced active, XLR connector
Output level +18 dBs
Output level adj. range +18 dBs to 20 dBs
Headphone output 20 mW (30 to 40 ohm)
Digital output
Transfer and connector Balanced active, XLR connector
Signal format S/PDif (IEC-958 Type II)8
Output level 3 Vp-p
Serial Remote RS-422A, D-Sub 9-pin
Parallel Remote D-Sub 25 pin

Power Supply AC120/230/240 V, 50/60 Hz
Power Consumption 25 W
Dimensions 144 (W) x 146 (H) x 401 (D) mm (with feet)
144 (W) x 133 (H) x 401 (D) mm
(without feet)
Weight 6.0 kg.