Denon DN-961FA Pro CD - CD-R Speler

DN-961FA Pro CD,CD-R speler in goede staat,voorzien van nieuwe laser-unit.

Supplied Accessories;
•AC power cord
•Operation manual

Ook 2e DN-961FA in goede staat te koop,voorzien van nieuwe laser-unit.

 2 Audio Channels,
stereo/mono selectable
D/A Conversion: 16-bit linear
Sampling Frequency: 44.1 kHz

• CD-R Reading Capability with or without T.O.C.
Can read CD-R discs without final TOC, such
as multi-session CD-Rs that have not been
finalized (TOC=Table Of Contents).

• Instant Start
Startup time is .01 second or less. A delay
start of 0.1, 0.2, or 0.3 second is available via
user preset. Startup via track flag or program
material beginning is possible.

• Auto Cue
The pickup is cued to the position within
the track where the sound starts and enters
standby mode. The sound detection level
can be set within a range of -36 to -72 dB.

• Back Cue
When the standby (STDBY/CUE) button is
pressed during playback, the standby mode
is set with the pickup at the position where
playback was last started.

• End Monitor
When the end monitor (END MON) button
is pressed in the standby mode, the end of
the track is searched for and the track’s
ending can be monitored. After monitoring,
the standby mode is set and the pickup is
set at the play start position. End monitor
start position can be user-set within a range
of 5 to 35 seconds from the end of the
track.

• Track Search
A pulse encoder-type rotary selector is used
for the track search operation. The tracks
can also be selected in units of 10 by pressing
the selector while turning it.

• Play Mode Selection
The ending mode can be selected separately
for single-track playback and continuous
playback:
- Single-track playback: Stop; Return to play
start position and standby; Standby at next
track
- Continuous playback: Stop; Return to play
start position and standby; Standby at beginning
of disc

• EOM (End Of Message)
A message indicating the track is about to
end is displayed and can be set within a
range of 5-35 seconds from the end of the
track

• Fader Start
The unit is equipped with a play start input
connector and delay start function, for use
with a mixing console fader.

• Variable Pitch

• Fade In (20 ms)

• Function Presets
Up to 28 different configuration selections
can be stored in memory to fully customize
the operation of the player according to the
installed requirements. Preset choices are
stored in non-volatile memory.

Frequency Response: 20 Hz-20 kHz, ±1 dB
Total Harmonic Distortion: 0.08% or less
S/N Ratio: 96 dB or greater, “A” weighted
Channel Separation: 90 dB or greater

Analog Outputs:
Active balanced output, XLR connector
Output Level: +18 dBm into 600 ohms impedance
Output Level Adjustment Range: +22 dBm to -20 dBm via rear panel
Output Impedance: Low impedance

Digital Output:
Active balanced transfer, XLR connector
Signal Format: Conforming to IEC-958
Output Level: 3 Vp-p or greater

Headphones Output: Stereo
Applicable Load: 30 to 40 ohms
Output Level: 20 mW or greater

Remote:
Parallel remote, D-sub 25 connector
via optional Denon RC-650 wired remote
RS-422A Serial remote, D-sub 9 connector

Power 220V,Consumption 25 W
Dimensions 144 (W) x 146 (H) x 401 (D) mm. Weight 6.0 kg.