Icom IC-775DSP

Icom IC-775DSP
Type: Amateur HF transceiver
Frequency range: TX: 10-160 m + WARC
RX: 0.1-30 MHz
Tuning steps: 1 / 10 / 20 / 50 Hz
1 / 9 / 10 KHz
1 MHz
Any step between 1 KHz to 1 MHz is also programmable
Frequency stability: ±30 Hz/hr 25°C (77°F), after 1 hr warmup
Mode: AM / FM / SSB / CW / RTTY
Channels / memory management: 99 regular
2 scan edge
RAM storage with lithium battery backup (CR-2032)
Repeater shift / offset: No dedicated. Use VFO A/B split instead
Power supply: Mains: 100-120 VAC or 220-240 VAC (Depending on market)
Current drain / power consumption: RX: 140-150 VA
TX: Max 760 VA
Antenna impedance / connector: 50 ohm (16.7-150 ohm with ATU) / Two SO-239
Dimensions (W*H*D): 424*150*390 mm (16.7*5.9*15.4")
Weight: 16.7 Kg (36.8 lb)
Other features: Electronic keyer and auto-ATU. CTCSS/PL. CI-V. VOX. Dual watch. AF-DSP




RECEIVER SECTION
Receiver system: Triple conversion superheterodyne (FM)
1st IF: 69.01 MHz
2nd IF: 9.01 MHz
3rd IF: 455 KHz
Quadruple conversion superheterodyne (AM/SSB/CW/RTTY)
1st IF: 69.01 MHz
2nd IF: 9.01 MHz
3rd IF: 455 KHz
4th IF: 10.695 MHz
Sensitivity: AM (10 dB S/N)
0.5-1.8 MHz: 13 uV
1.8-30 MHz: 2 uV
FM (12 dB SINAD)
28-30 MHz: 0.5 uV
SSB/CW/RTTY (10 dB S/N)
0.1-0.5 MHz: 2 uV
1.8-30 MHz: 0.16 uV
Selectivity: AM (Normal filter selection)
>6 KHz (-6 dB)
15 KHz (-6 dB)
2.4 KHz (-6 dB)
500 Hz (-6 dB)
<1 KHz (-60 dB)
Image rejection: 70 dB
AF output power / speaker: 2.6 W at 10% distortion / 8 ohm
External speaker connector: 3.5 mm




TRANSMITTER SECTION
RF output power:

Pwr
AM: 5-50 W
FM: 5-200 W
SSB (PEP): 5-200 W
CW/RTTY: 5-200 W
Modulation system:
Max FM deviation (Factory set): ±? KHz
Spurious emissions: Better than -60 dB
Microphone impedance / connector: 600 ohm / 8-pin (Metal locking ring connector)
Microphone input level: ? mV


Unfortunately a button is missing and the lighting is dim and there are no instructions Condition S.Photos
Only pickup 20Km van Enschede