Kenmerken

Conditie
Gebruikt
Vermogen
60 tot 120 watt
Merk

Beschrijving

Topversterker net onder toenmalig topmodel TA-F555ES II.

Extremely Standard. Extremely Heavy. Extremely Anthraciet-Donkerbruin-Zwart.

Een grote versterker, 13,3 kilo luisterplezier.
Nieuwprijs ooit 1399 Gulden.
In hele nette gebruikte staat.
Een beetje transformatorbrom hoort erbij na bijna veertig jaar.
Nog geen kraak te horen, een vlek bovenop, vast ergens een krasje. Ik hebt het zo goed mogelijk proberen te fotograferen. De rest is vooral stof, dat zie je meteen op al dat Anthraciet-Donkerbruin-Zwart.
Door dat Donkerbruin een hele sjieke uitstraling met geanodiseerd front en metalen knoppen. Alles voelt degelijk en mechanisch, een genot om te zien, voelen en horen.
Met hoogwaardige Phono-aansluiting voor een platenspeler, MM en MC.
Meer plaatjes en info op het www.

The TA-F444ES is an 80-wpc amplifier featuring Sony’s Audio Current Transfer (ACT) technology. This circuit transferred current, not voltage, from one stage to another, which apparently maintained better channel separation, increased the SNR, and allowed for greater frequency extension than more ordinary designs. The power supply in this unit was also built to a very high standard, featuring a single large EI core transformer with dual secondaries. This meant that each channel, in essence, had its own power supply, much like the comparable (and contemporary) h/k PM660. Each channel had its own rectifier diodes, and two 63v/12,000uFd (four total) Elna for Audio power filter caps.

The fit and finish of the unit is excellent. The anodized aluminum front panel is well laid out and labeled. All knobs are cast aluminum and are held to their shafts with hex-key set screws. The volume control (“Attenuator” in Sony speak) is on the left side of the panel, which is different, and has a two-color status LED embedded in it. Red indicates a fault, flashing amber indicates startup sequence, and green indicates normal operation. Around back, the speaker connectors are excellent. The only down side to them is that you must use either bare wire or pins: Spade connectors and banana jacks will not work. All input RCA’s are standard aluminum affairs, except the phono input, which is gold plated.
...
...
...
...
...
...
...
...
...
...
...
...
Utrecht
270x bekeken
3x bewaard
Sinds 26 feb '26
Advertentienummer: m2370915808