Te koop aangeboden,

Kent-Moore EN48018 Flywheel Holding Tool.

Prijs is €100.- ex btw

This is a G.M. specific tool, check your workshop manual if this is the right tool for your application.
This is a used item, as shown in pictures, item is in good working order.

Northstar engine, check your workshop manual for your application.

The Kent-Moore EN-48018 Flywheel Holding Tool holds the flywheel from the bottom through the bell housing inspection hole.
The flywheel must be held on-vehicle for various service procedures.
EN-48018 will hold the flywheel from the bottom, through the bell housing inspection hole.
EN-48018 installs in place of two bell housing bolts, and engages the ring gear teeth to hold the flywheel.
Unapproved methods may damage the flywheel.

Kent-Moore Automotive Division
SPX Corporation
PN EN48018

This item can not be returned!

Verzenden doen wij met DHL en hanteren verzendkosten vanaf €12.50 ex btw.

Wij zijn van maandag tot en met vrijdag tussen 9.00-12.30 en 13.00-17.00 geopend, in het weekend en feestdagen gesloten.