I am selling my project because I am moving and I will not have time to finish it.

This was my project that I built over past few months.

It consist of AWD system with High Speed HT stepper motors together with custom watercooled plates to keep them cold and happy.

4X LDO NEMA17 Speedy Power HT - LDO-42STH48-2504AH

Everything runs on Octopus Max Ez Board together with 4X 48V external drivers for AWD system from BTT.

AWD system runs on 9MM belts and its made out of aluminium together with Z axis (there are NO printed parts)

Toolhead is a custom made by me (printed in SLS PACF12) It comes with Goliath hotend and Orbiter 2.0 extruder, theres also a Cartographer 3D probe for the bed scanning.

I have two PSU one for 48V (LRS-600) another one for 24V, comes with BTT Pi.

Hotend and motors are watercooled (I have pump and radiator)

Bed is custom made and comes with kinematic expansion kit

It also comes with extra extrusions on the sides (I wanted to make doom project)

i can give you other stuff that I still have, two octopus board, wiring stuff etc....
Sunlu is gratis, two filaments (pacf12 also)

There is a lot of 2020 extrusions, and also second cnc kit, basically you can build second printer out of it.

I have bed for this printer and its size would be 350x350x750!

What do you have to do to make it run?

- connect motors on gantry
- finish rest of the wiring
-configure board
- install bed and casing if you need

if u have any questions ask me.